Removal & Installation (Blazer & Jimmy Canadian 2-Door)
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
Raise and support vehicle. Remove shield behind left rear wheelwell, near fuel tank, to access EVAP canister. See Fig 1. Remove EVAP canister retainer. See Fig 2. Disconnect vent hose from EVAP canister. Disconnect fuel tank fill pipe and purge pipe from EVAP canister. Remove EVAP canister. To install, reverse removal procedure. Check for leaks.