LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 432 (Engine Mechanical - 2.2L (On-Vehicle)) >> Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sonoma and 2002 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
    NOTE: Do not damage the crankshaft surface when prying out the crankshaft rear oil seal.
  2. Remove the crankshaft rear oil seal. Pry the crankshaft rear oil seal out with a suitable pry tool.
    Fig 1: Removing Crankshaft Rear Oil Seal
    G01658947Courtesy of GENERAL MOTORS CORP.
  3. Clean the crankshaft rear oil seal to engine block mating surface.
  4. Inspect the following areas:
    • Inspect the seal bore for nicks
    • Inspect the seal bore for burrs
    • Inspect the seal mating surface on the crankshaft for nicks
scientia non olet · About LEMON Manuals