LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 431 (Engine Mechanical - 6.5L (On-Vehicle)) >> Removal & Installation >> Drive Belt >> Removal

Drive Belt: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly. Remove the coolant recovery bottle bolt. Remove the coolant recovery bottle and set aside. Install a 3/8 inch drive wrench on the tensioner arm and rotate the arm counterclockwise.
  2. Remove the drive belt from the drive pulleys. See Fig 1 and Fig 2 . Slowly release the tension on the tensioner arm.
Fig 1: Serpentine Belt Routing (With Single Generator)
G00040881Courtesy of GENERAL MOTORS CORP.
Fig 2: Serpentine Belt Routing (With Dual Generator)
G00025009Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals