LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 431 (Engine Mechanical - 6.5L (On-Vehicle)) >> Removal & Installation >> Crankshaft Oil Seals >> Removal & Installation (Front)

Removal & Installation (Front)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Required Tools: Seal Installer (J-22102).

Remove the crankshaft balancer from the crankshaft. See CRANKSHAFT BALANCER . Remove the crankshaft front cover oil seal from the engine front cover. Apply a small amount of clean engine oil to the sealing surface of the crankshaft balancer. Apply a small amount of clean engine oil to the inner sealing surface of the oil seal. Use the Seal Installer to install the crankshaft front cover oil seal. Install the crankshaft balancer to the crankshaft. See CRANKSHAFT BALANCER .

scientia non olet · About LEMON Manuals