LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 428 (Engine Mechanical - 8.1L V8) >> Removal & Installation >> Exhaust Manifold Pipe >> Removal

Exhaust Manifold Pipe: Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Suburban, and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle.
  2. Remove oil pan skid plate bolts and plate, if necessary.
  3. Support transmission with a transmission jack.
  4. Remove transmission mount-to-transmission support nuts.
  5. Raise transmission off of the transmission support.
  6. Remove transmission support crossmember bolts.
  7. Remove transmission support crossmember.
  8. Remove muffler. See MUFFLER REPLACEMENT .
  9. Remove clip around engine harness and oxygen sensor pigtail.
  10. Disconnect the Connector Position Assurance (CPA) retainer.
  11. Disconnect oxygen sensor electrical connector.
  12. Remove oxygen sensor.
  13. Remove exhaust manifold pipe.
  14. Slide exhaust manifold pipe hanger out of the exhaust pipe hanger bracket.
  15. Discard exhaust manifold pipe seal.
scientia non olet · About LEMON Manuals