LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 428 (Engine Mechanical - 8.1L V8) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Suburban, and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure crankshaft is free of grit, loose rust, and burrs. Correct as needed.
  2. Apply a very light film of oil onto the crankshaft sealing surface. DO NOT apply oil to sealing surface of engine block.
  3. Using Crankshaft Rear Seal Installer (J-42849), install rear sea to installer.
  4. Position crankshaft rear seal installer against crankshaft. Thread the attaching screws into the tapped holes in crankshaft.
  5. Tighten screws securely with a screwdriver in order to ensure that the seal is installed squarely over the crankshaft.
  6. Rotate the center nut until crankshaft rear seal installer bottoms.
  7. Remove crankshaft rear seal installer.
  8. Install flywheel.
scientia non olet · About LEMON Manuals