Clutch Pilot Bearing Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 38836 Pilot Bushing Installer/Clutch

IMPORTANT: The flywheel spacer (if applicable) must be removed prior to pilot bearing installation.

Install a 5/8 inch washer (1) onto the J 38836 or equivalent.
Install the new pilot bearing (2) onto the tool.

Fig 1: J 38836, Washer & Pilot Bearing
Courtesy of GENERAL MOTORS CORP.
Install the new pilot bearing into the crankshaft using the J 38836 .

Fig 2: Installing Pilot Bearing Using J 38836
Courtesy of GENERAL MOTORS CORP.
Inspect the clutch pilot bearing for proper installation.

Fig 3: Pilot Bearing Proper Installation Position
Courtesy of GENERAL MOTORS CORP.