LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0443: EVAP Purge Solenoid Control Circuit >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step number in the diagnostic procedures.

  1. 2

    This step tests if the concern is active. The EVAP purge valve is PWM. An audible clicking should be heard when the purge valve is commanded to 50 percent and should stop when the EVAP purge valve is commanded to 0 percent. The rate at which the valve cycles should increase as the commanded state is increased and decrease as the commanded state is decreased. Repeat the commands as necessary.

  2. 5

    This step tests if a ground is constantly being applied to the EVAP purge solenoid

  3. 6

    This step verifies that the control module is providing ground to the EVAP purge solenoid.
scientia non olet · About LEMON Manuals