Test Description

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Chevrolet Monte Carlo, 2003 Chevrolet Impala, and 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers in the diagnostic procedures.

14

This test verifies if the sensor is working correctly. By suppling a ground to the circuit, the voltage should change when the circuit is touched with a test light.

26

This step determines if the fault is caused by a missing camshaft magnet or by a faulty PCM. The voltage measured in this step should be near 5 volts, and decrease to near 0 volts when the CMP sensor interfaces with the camshaft magnet.