Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
- Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
- Use the tilt lever to tilt the column to the UP position.
- Remove one end of the tilt spring (1) from the steering column support assembly (2) and the other end from the steering column tilt head assembly (3) by using the following procedure:
- Pry up the tilt spring (1) until a bulge occurs and most of the tilt spring tension is removed.
- Secure the tilt spring (1) with locking pliers.
- Continue prying up the tilt spring (1) until the tilt spring disengages from the post on the steering column support assembly (2) and from the steering column tilt head assembly (3).
- Remove the spring guide (1) from the tilt spring (2).
CAUTION:
Refer to SIR CAUTION
.
CAUTION:
The tilt spring and the spring guide are under pressure. The tilt spring and the spring guide may become a projectile. Secure the spring with locking pliers during removal. Secure the spring with locking pliers during installation. Bodily injury may result during removal and installation of the tilt spring and the spring guide. Always use caution during removal and installation of the tilt spring and the spring guide.