LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Wheel, Steering Wheel Shaft & Nut
    GM731652Courtesy of GENERAL MOTORS CORP.
  1. Install the steering wheel to the steering wheel shaft.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining nut that secures the steering wheel to the steering wheel shaft.

    Tighten:  Tighten the retaining nut to 41 N.m (30 lb ft).

    3. Fig 2: Connecting Steering Wheel Electrical Connector
    GM731656Courtesy of GENERAL MOTORS CORP.
  3. Connect the steering wheel electrical connector.
  4. Install the horn plunger to the steering column.
  5. Install the inflator module. Refer to AIR BAG MODULES .
  6. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals