LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR CAUTION .
  1. Disable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove the steering wheel from the column. Refer to Steering Wheel Replacement .
  3. Remove the ignition lock cylinder case assembly. Refer to Ignition Lock Cylinder Case Replacement .
  4. Remove the turn signal and multifunction switch assembly. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement .
  5. Slide the turn signal switch housing off of the steering column shaft assembly.
    Fig 1: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly
    GM664269Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals