LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Steering Wheel & Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement - Lower >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Intermediate Shaft Boot & Power Steering Gear
    GM731640Courtesy of GENERAL MOTORS CORP.
  1. Install the lower intermediate shaft to the vehicle.
  2. Connect the lower intermediate shaft to the power steering gear.
  3. NOTE: Refer to FASTENER NOTICE .
  4. Install the lower intermediate shaft to the power steering gear input shaft pinch bolt.

    Tighten:  Tighten the lower intermediate shaft to the power steering gear input shaft pinch bolt to 40 N.m (29 lb ft).

  5. Lower the vehicle.
  6. Fig 2: Lower Intermediate Shaft & Upper Intermediate Shaft
    GM731643Courtesy of GENERAL MOTORS CORP.
  7. Install the lower intermediate shaft boot and connect the lower intermediate shaft boot to the power steering gear.
  8. Fig 3: Steering Column To Steering Gear Connection
    GM687445Courtesy of GENERAL MOTORS CORP.
  9. Connect the lower intermediate shaft to the upper intermediate shaft.
  10. Install the lower intermediate shaft to the upper intermediate shaft pinch bolt.

    Tighten:  Tighten the lower intermediate shaft to the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

  11. IMPORTANT: The upper intermediate shaft boot must completely cover the white insert of the lower intermediate shaft boot to ensure proper sealing.
  12. Connect the upper intermediate shaft boot to the lower intermediate shaft boot.
  13. Fig 4: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  14. Unlock the steering column by removing J 42640 from the steering column lower trim cover access hole.