Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE .

Fig 1: View Of Lock Cylinder Housing TORX Screws

Courtesy of GENERAL MOTORS CORP.

Install 3 TORX® screws into the lock cylinder housing.
Tighten: Tighten the TORX® screws to 7N.m(62 lb in).
Install the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement - On Vehicle .
Install the park lock cable into the lock cylinder housing.
Install the ignition switch. Refer to Ignition Switch Replacement .
Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .