Steering Column Tilt Function Inoperative
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Steering Column Tilt Function Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column - Tilt Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Steering Wheel and Column |
| 2 | Verify that the steering column tilt function is inoperative. Does the steering column tilt function operate normally? |
System OK | Go to Step 3 |
| 3 | Verify that the shoe is not seized on the pivot pin. Is the shoe seized on the pivot pin? |
Go to Step 9 | Go to Step 4 |
| 4 | Inspect the shoe grooves for dirt, burrs, or rust. Are the shoe grooves free of dirt, burrs, and rust? |
Go to Step 9 | Go to Step 5 |
| 5 | Inspect weak or broken shoe lock spring. Is the shoe lock spring weak or broken? |
Go to Step 9 | Go to Step 6 |
| 6 | Inspect the pivot pins for binding. Are the pivot pins binding? |
Go to Step 10 | Go to Step 7 |
| 7 | Inspect for a weak or broken wheel tilt spring. Is the wheel tilt spring weak or broken? |
Go to Step 11 | Go to Step 8 |
| 8 | Inspect the steering column wiring harness for tightness. Is the steering column wiring harness too tight? |
Go to Step 12 | Go to Step 3 |
| 9 | Replace the tilt head. Refer to Steering Column Tilt Head Replacement . Is the repair complete? |
Go to Step 13 | - |
| 10 | Replace the pivot pins. Refer to Steering Column Tilt Head Replacement . Is the repair complete? |
Go to Step 13 | - |
| 11 | Replace the tilt spring. Refer to Tilt Spring Replacement - Steering Column . Is the repair complete? |
Go to Step 13 | - |
| 12 | Reroute the steering column wiring harness to the correct location. Is the steering column wiring harness routed properly? |
Go to Step 13 | - |
| 13 | Operate the steering column tilt function in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |