LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 419 (Engine Mechanical - 3.5L (On-Vehicle)) >> Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Disconnect the electrical connector from the engine oil pressure switch.
  3. Remove the engine oil pressure switch from the engine block.
    Fig 1: Removing Engine Oil Pressure Switch
    G01816956Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals