LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 419 (Engine Mechanical - 3.5L (On-Vehicle)) >> Repair Instructions >> Crankshaft Front Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
  2. Do not gouge the front cover when prying out the front cover seal. The seal will remove easily.

    Remove the front cover seal with a small pry bar or a flat-bladed tool.

    Fig 1: Removing Front Cover Seal
    G01816709Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals