LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 419 (Engine Mechanical - 3.5L (On-Vehicle)) >> Repair Instructions >> Balance Shaft Opening Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Remove the balance shaft cover bolts.
  3. Lift the balance shaft cover from the engine valley.
  4. Remove the balance shaft cover gasket. Carefully scrape any remaining gasket material from the cylinder block and cover plate.
  5. Clean and inspect the balance shaft cover. Refer to BALANCE SHAFT CLEANING AND INSPECTION in Engine Mechanical-3.5L Unit Repair.
    Fig 1: Removing Balance Shaft Opening Cover
    G01816658Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals