LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 418 (Engine Mechanical - 4.2L 6-Cylinder (On-Vehicle)) >> Repair Instructions >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the drive belt over all the pulleys except the drive belt tensioner pulley.
  2. Install the 3/8 inch breaker bar on the drive belt tensioner arm and turn the breaker bar clockwise.
  3. Install the drive belt over the drive belt tensioner pulley.
  4. Slowly release the tension to the drive belt tensioner arm.
  5. Inspect for proper installation of the drive belt on the pulleys.
scientia non olet · About LEMON Manuals