LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (HVAC Systems - Manual) >> Removal & Installation >> Compressor Hose >> Installation

Compressor Hose: Installation

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new seal washers to the compressor ports. Install the hose to the compressor and install the bolt. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
  2. Install the new seal washer to the accumulator end of the compressor hose. Install the compressor hose assembly and nut to the accumulator. Tighten the nut to specification.
  3. Install the right front fender liner. Lower the vehicle. Install the new seal washer to the condenser end of the compressor hose. Install the compressor hose and nut to the condenser. Tighten the nut to specification.
  4. Install the compressor hose bracket and bolt to the fan shroud. Tighten the bolt to specification. Install the refrigerant pressure sensor O-ring to the new hose. Install the refrigerant pressure sensor to the new hose. Evacuate and charge the refrigerant system.
scientia non olet · About LEMON Manuals