Diagnostic Aids
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
Inspect for the following conditions:
- Inspect the harness of the MAF sensor to verify that it is not routed too close to the following components:
- The ignition coil cassette.
- Any solenoids.
- Any relays.
- Any motors.
- Inspect for any contamination or debris on the sensing elements of the MAF sensor.
- A Wide Open Throttle (WOT) acceleration from a stop should cause the MAF SENSOR parameter on the scan tool to increase rapidly. This increase should be from 3-10 g/s at idle to 190 g/s or more at the time of the 1-2 shift. If the increase is not observed, inspect for a restriction in the induction system or the exhaust system.
- A high resistance of 15 ohms or more on the ground circuit of the MAF sensor may cause this DTC to set. A high resistance may cause a driveability concern before this DTC sets.
- A high resistance of 15 ohms or more on the ignition 1 voltage circuit may cause this DTC to set. A high resistance may cause a driveability concern before this DTC sets.
Condition may be related to aftermarket accessories. If the condition is intermittent, see INTERMITTENT CONDITIONS under SELF-DIAGNOSTIC SYSTEM.