LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (HVAC Systems - Manual) >> Removal & Installation >> Suction Hose >> Removal (All Models)

Removal (All Models)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING. Remove the suction hose mounting bolt from the A/C compressor. Remove the suction hose from the A/C compressor. See Figure.
  2. Remove the suction hose nut from the accumulator. See Fig 1. Remove the suction hose from the accumulator. Remove the suction hose assembly from the vehicle. Discard all of the used sealing washers. Cap the system openings.
Fig 1: Removing & Installing Suction Hose At Accumulator
G00223823Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals