LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (HVAC Systems - Manual) >> Removal & Installation >> Condenser >> Removal (All Models)

Removal (All Models)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING. Remove the grille. Remove the tie bar to radiator brace bolts. Access the bolts from the rear of the upper radiator support. See Fig 1.
  2. Remove the lower bolts from the hood latch support bracket. See Fig 2. Remove the compressor discharge hose assembly bolt from the condenser. Disconnect the compressor discharge hose assembly from the condenser. See Fig 3.
  3. Remove the evaporator tube nut from the condenser. Disconnect the evaporator tube from the condenser. See Fig 4.
  4. Remove the insulator retainer bolts and the upper insulator retainers. Remove the condenser from the vehicle. See Fig 5.
Fig 1: Removing & Installing Tie Bar To Radiator Brace
G00218189Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Bolts At Hood Latch Support Bracket
G00218190Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing & Installing Compressor Discharge Hose Assembly
G00218191Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing & Installing Evaporator Tube Nut
G00218192Courtesy of GENERAL MOTORS CORP.
Fig 5: Removing & Installing Insulator Retainer Bolts & Upper Insulator Retainers
G00218193Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals