Removal (Front)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

If equipped, remove the sound insulator panel. Remove the blower motor insulating cover screws. Disconnect the electrical connector from the blower motor.
Remove the blower motor insulating cover. Pull the retaining tab down while turning the blower motor counterclockwise in order to disengage the blower motor from the heater/vent module. See Fig 1. Remove the blower motor. See Fig 2.

Fig 1: Disengaging The Blower Motor From HVAC Module

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing & Installing Blower Motor

Courtesy of GENERAL MOTORS CORP.