LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (HVAC Systems - Manual) >> Removal & Installation >> Blower Motor Resistor >> Removal (Auxiliary - Avalanche, Escalade, Suburban, Tahoe, Yukon)

Removal (Auxiliary - Avalanche, Escalade, Suburban, Tahoe, Yukon)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Remove the right rear quarter trim panel. Disconnect the electrical connector from the blower motor resistor. Remove the retaining screws from the blower motor resistor. Remove the blower motor resistor from the vehicle.

Fig 1: Removing & Installing Auxiliary Blower Motor Resistor
G00218186Courtesy of GENERAL MOTORS CORP.