Bleeding Hydro-Boost System
WARNING: This page does not describe the selected car, but rather 35 other vehicles, including the 1999 GMC Yukon, 1999 GMC Suburban, 1999 GMC Sierra, 1999 GMC Savana Special, and 1999 GMC Savana Camper Special. However, it is still accessible from the selected car via links, so may be relevant.
- Fill power steering pump reservoir and leave undisturbed for at least 2 minutes. Start engine and run momentarily. Add fluid if necessary. Repeat until fluid level remains constant with engine running.
- Stop engine. Raise front wheels off the ground. Turn steering wheel from stop-to-stop. Add fluid if necessary. Lower vehicle.
- Start engine. Press brake pedal several times while turning steering wheel from stop-to-stop. Turn engine off. Press brake pedal several times to exhaust accumulator pressure. Check fluid level. Add fluid (if necessary).
- If fluid is foamy, let vehicle stand for several minutes, then repeat step 3. Air in system will cause fluid level to rise with engine off. Continue to bleed system until all air is expelled. If all air is not expelled after bleeding system, check power steering system for problem.