LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 391 (Engine Controls - Removal & Installation) >> Sensors >> Crankshaft Position Sensor >> Installation

Crankshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2003 Pontiac Bonneville, 2003 Buick Park Avenue, and 2003 Buick LeSabre. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the CKP sensor. Install the CKP sensor bolts. Tighten the bolts to specification. See TORQUE SPECIFICATIONS . Install the CKP sensor shield. Connect the CKP sensor electrical connector.
  2. Coat the engine front cover seal contact area on the crankshaft balancer, and the seal surface with clean engine oil. Install the crankshaft balancer. Install the crankshaft balancer retaining bolt. Use the Flywheel Holder (J-37096) to keep the flywheel from turning. Tighten the crankshaft balancer bolt to specification.
  3. Remove the flywheel holder. Install the torque converter cover. Install the right engine splash shield and the engine splash shield retainers. Install the right front tire and wheel. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS .
  4. Lower the vehicle. Install the drive belt. Reconnect the negative battery cable. Perform the CKP System Variation Learn Procedure. See PROGRAMMING .
scientia non olet · About LEMON Manuals