LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Power Rack & Pinion Steering System) >> Removal & Installation >> Steering Gear >> Removal

Steering Gear: Removal

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle on hoist, and remove wheels and tires. Remove the stabilizer shaft links from the control arms.
  2. Separate tie rod ends from struts using Separator (J-24319-01). See Figure . Remove intermediate shaft lower pinch bolt from steering gear.
  3. Support rear of chassis support frame, and remove the stabilizer shaft.
  4. Remove power steering hoses. Remove steering gear bolts from frame. Remove steering gear through driver side wheel opening.
scientia non olet · About LEMON Manuals