LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Controls - Removal & Installation - Flex Fuel & Gasoline) >> Sensors >> Manifold Absolute Pressure Sensor >> Removal (4.8L, 5.3L & 6.0L)

Removal (4.8L, 5.3L & 6.0L)

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine sight shield. See ENGINE SIGHT SHIELD  under MISCELLANEOUS.
  2. Disconnect Manifold Absolute Pressure (MAP) sensor harness connector. See Figure. Remove MAP sensor from intake manifold. Inspect MAP sensor seal for damage. Replace, if necessary.
scientia non olet · About LEMON Manuals