LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Controls - Removal & Installation - Flex Fuel & Gasoline) >> Sensors >> Engine Coolant Temperature Sensor >> Installation

Engine Coolant Temperature Sensor: Installation

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Whenever ECT sensor is removed, coat threads with Sealer (12346004) before reinstallation. Install ECT sensor into engine and tighten to specification. See TORQUE SPECIFICATIONS .
  2. On 8.1L models, install the ECT sensor electrical connector to the oil fill tube bracket. Connect the ECT sensor electrical connector. On 4.3L, 4.8L, 5.3L and 6.0L models, reconnect harness connector to ECT sensor.
  3. On all models, reconnect negative battery cable. Tighten the negative battery cable bolt. to specification. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING  under COOLING SYSTEM.
scientia non olet · About LEMON Manuals