LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Controls - Removal & Installation - Flex Fuel & Gasoline) >> Sensors >> Crankshaft Position Sensor >> Removal (4.8L, 5.3L & 6.0L)

Removal (4.8L, 5.3L & 6.0L)

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Raise and support vehicle. Remove right flywheel cover bolt. See Figure. Remove starter mounting bolts. Disconnect oil level sensor harness connector. Slide starter forward until starter clears transmission. Disconnect electrical connectors from starter solenoid. Remove starter.
  2. Clean area around Crankshaft Position (CKP) sensor before removal to prevent debris from entering engine. Disconnect CKP sensor harness connector. Remove CKP sensor retaining bolt and CKP sensor. See Figure.
scientia non olet · About LEMON Manuals