LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 387 (Engine Controls - Removal & Installation - Flex Fuel & Gasoline) >> Ignition Systems >> Ignition Control Module >> Installation

Ignition Control Module: Installation

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the ignition control module and heat sink. Install ignition control module screws. Tighten the screws to specification. See TORQUE SPECIFICATIONS .
  2. Connect the ignition coil driver electrical connector. Install the air cleaner resonator outlet duct. See AIR CLEANER RESONATOR OUTLET DUCT  under AIR INDUCTION SYSTEMS.
scientia non olet · About LEMON Manuals