Inspection Procedure
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Remove EVAP canister purge solenoid. See EVAP CANISTER PURGE SOLENOID . Lightly tap the EVAP canister purge solenoid on a clean, hard surface. Inspect for carbon particles exiting either of the vacuum ports. If no carbon particles are found, reinstall EVAP canister purge solenoid and perform CLEANING PROCEDURE .
- If carbon particles are found during the inspection procedure, replace EVAP canister purge solenoid and perform CLEANING PROCEDURE . If you were instructed to replace the EVAP canister purge solenoid, and no carbon particles are found, return to the EVAP diagnostic procedure. DO NOT perform the CLEANING PROCEDURE .