LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 385 (Engine Controls Self-Diagnostics) >> Diagnostic Tests >> DTC P0134 & P0154: Ho2S Circuit - Insufficient Activity - Bank 1 & 2, Sensor 1 >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers in the diagnostic procedures.

  1. 4

    If the scan tool indicates the HO2S voltage goes below 200 mV, this indicates the HO2S circuits and PCM are okay.

  2. 5

    This step verifies whether the low signal circuit from the PCM is okay. A voltage indicates the PCM and wiring are okay.

  3. 6

    This step verifies whether the signal circuit from the PCM is okay.

  4. 7

    Disconnecting the PCM allows using a Digital Volt-Ohmmeter (DVOM) in order to test the circuit continuity. This procedure helps to locate an open or a shorted circuit.

scientia non olet · About LEMON Manuals