LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 382 (Engine Controls - Removal & Installation) >> Fuel Systems >> Fuel Pressure Dampener (2.2L) >> Installation

Fuel Pressure Dampener (2.2L): Installation

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. "O" rings must be lubricated with clean engine oil and installed into the fuel rail before the fuel pressure regulator is installed. Install the small oiled "O" ring into the fuel rail. Install the large oiled "O" ring into the fuel rail.
  2. Install the fuel pressure regulator into the fuel rail. Install the retaining bolts. Tighten the fuel pressure dampener bolts to specification. See TORQUE SPECIFICATIONS  .
  3. Install the outlet resonator/duct assembly. See AIR CLEANER OUTLET RESONATOR/DUCT ASSEMBLY  under AIR INDUCTION SYSTEMS.
  4. Connect the negative battery cable. Tighten the battery terminal bolt to specification. Run the vehicle and inspect for leaks. Reset all preset radio stations and set clock to correct time.
scientia non olet · About LEMON Manuals