LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 377 (Engine Controls - Self-Diagnostics - 4.3L) >> Diagnostic Tests >> DTC P0103: MAF Sensor Circuit - High Frequency >> Test Description

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Sonoma, 2003 GMC Safari, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers in the diagnostic procedures.

  1. 3 -  This step tests for Electromagnetic Interference (EMI) on the signal circuit of the MAF sensor. A frequency reading with the MAF sensor disconnected indicates an EMI related fault or a poor connection. Disconnecting the MAF sensor may set additional related DTCs.
  2. 4 -  This step eliminates any conditions which can cause a DTC to set with a normally operating MAF sensor.

scientia non olet · About LEMON Manuals