LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 376 (Rear Suspension System) >> Removal & Installation >> Rear Axle Upper Control Arm >> Removal

Rear Axle Upper Control Arm: Removal

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Disconnect the Real Time Damping (RTD) sensor harness connector from the vehicle harness connector (if equipped).
  3. Remove the retaining nut and bolt from the frame bracket at the front of the upper control arm. See Fig 1 .
  4. Remove the retaining nut and bolt from the axle bracket at the rear of the upper control arm. See Fig 2 .
  5. Remove the upper control arm.
Fig 1: Removing & Installing Front Of Upper Control Arm
G00136214Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Rear Of Upper Control Arm
G00136215Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals