LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 376 (Rear Suspension System) >> Removal & Installation >> Rear Axle Lower Control Arm >> Installation

Rear Axle Lower Control Arm: Installation

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower control arm.
  2. Install the lower control arm retaining bolts. See Figure .
    3. NOTE: DO NOT tighten the bolts unless the suspension is at the curb ride height.
  3. Install the lower control arm retaining nut. DO NOT tighten control arm retaining nut at this time.
  4. Remove the rear axle support.
  5. Lower the vehicle. Tighten the lower control arm retaining nuts to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals