LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 370 (Engine Control System - Self-Diagnostics - 4.2L) >> Diagnostic Tests >> DTC P1523: Throttle Closed Position Performance >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Are any other DTCs set? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, go to next step.
  3. Turn ignition off for 15 seconds. Turn ignition on, with engine off. Allow the pedal to rest at idle stop for 20 seconds. With scan tool, observe the indicated throttle position parameter. Does scan tool indicate throttle position of 10.8-23.2 percent? If yes, go to step  6. If no, go to next step.
  4. Remove throttle body assembly. Did you find any obstructions preventing the throttle blade from returning to the default position? If yes, go to next step. If no, go to step  6.
  5. Remove obstruction. After repairs, go to step  7.
  6. Replace throttle body assembly. See REMOVAL & INSTALLATION - BRAVADA, ENVOY, ENVOY XL, TRAILBLAZER & TRAILBLAZER EXT article. After repairs, go to next step.
  7. Clear the DTCs with scan tool. Turn ignition off for 30 seconds. Start engine. Operate vehicle within the Conditions For Running DTC. Does the DTC run and pass? If yes, go to next step. If no, go to step  2.
  8. Observe the stored information, Capture Info with scan tool. Does scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.