LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Rear Suspension System) >> Removal & Installation >> Stabilizer Shaft >> Installation (Shaft)

Installation (Shaft)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft to the rear suspension support. See Figure.
  2. Install the stabilizer shaft insulator brackets and hand tighten the bolts. Do not tighten the bolts at this time.
  3. Install the right and left stabilizer shaft link nuts to the stabilizer shaft links. See Figure.
    • Tighten the stabilizer shaft link nuts to 38 Ft. Lbs. (52 N.m).
    • Tighten the stabilizer shaft insulator bracket nuts to 35 Ft. Lbs. (48 N.m).
  4. Install the tires and wheels.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals