Wheel Bearing
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Tools Required: Dial Indicator (J-8001).
- Raise and support the vehicle.
- Mount and secure the J-8001 to a stand.
- Ensure that the J-8001 contacts the vertical surface of the wheel as close as possible to the top wheel stud.
- Push and pull on the top of the tire.
- Inspect the total movement indicated by the J-8001.
- If the measurement exceeds 0.005" (0.127 mm), replace the wheel bearing/hub. See HUB & BEARING ASSEMBLY .
NOTE:
If you are inspecting the front wheel bearing/hub, support the front of the vehicle by the lower control arms in order to load the lower ball joint.