LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Engine Controls - Removal & Installation) >> Sensors >> Fuel Tank Pressure Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Remove the fuel tank. See FUEL TANK  . Disconnect the electrical connector from the fuel tank pressure sensor. Remove the fuel tank pressure sensor from the fuel sender assembly. See Figure . To install, reverse removal procedure.

scientia non olet · About LEMON Manuals