LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Engine Controls - Removal & Installation) >> Sensors >> Crankshaft Position Sensor "A" (24X) >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Crankshaft Position (CKP) sensor is located behind the crankshaft balancer. See Figure . Turn the ignition off. Remove the drive belt. Raise and support the vehicle.
  2. Remove the right front tire and wheel. Remove the right engine splash shield. Install a utility stand beneath the frame right side rail in order to support the frame/powertrain. Remove the two frame right side bolts. Use the utility stand to lower the frame enough to provide access to the crankshaft balancer.
  3. Remove and discard the crankshaft balancer bolt. Using Crankshaft Balancer Puller (J-24420-C), remove the crankshaft balancer. Note the routing of the CKP sensor harness before removal. Remove the harness retaining clip and bolt. Disconnect the CKP sensor electrical connector. Remove the sensor bolts. Remove the CKP sensor.
scientia non olet · About LEMON Manuals