LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Engine Controls - Removal & Installation) >> Ignition Systems >> Spark Plugs >> Removal

Spark Plugs: Removal

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. To remove spark plugs from left cylinder bank (front cylinder head), remove the spark plug wires from spark plugs. Remove spark plugs from engine. To remove spark plugs from the right cylinder bank (rear cylinder head), remove the throttle air cleaner intake duct. See AIR CLEANER INTAKE DUCT  under AIR INDUCTION SYSTEMS.
  2. Set the park brake. Shift the transaxle into Neutral. Remove the engine mount strut bolts. See Fig 1 . Swing the engine mount struts aside. Install the Engine Tilter Strap (J-41131) to the engine. See Fig 2 .
  3. Pull on the engine in order to rotate the engine forward. Tighten the engine tilter strap. Remove the spark plug wires from the spark plugs. Remove the spark plugs from the engine.
Fig 1: Removing Left Engine Mount Strut Bolt (Right Is Similar)
G00114740Courtesy of GENERAL MOTORS CORP.
Fig 2: Installing Engine Tilter Strap
G00114739Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals