Removal & installation

WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Battery is located underneath rear seat cushion. Remove the rear seat cushion. Disconnect the negative battery cable from the battery. To install, reverse removal procedure. Tighten battery cable bolt to specification. See TORQUE SPECIFICATIONS .