LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 368 (Engine Controls - Removal & Installation) >> Ignition Systems >> Ignition Coil(S) >> Removal (Bank 2)

Removal (Bank 2)

WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bank 2 is the cylinder head that is closest to the front of engine compartment. Turn ignition off. Remove mounting the 2 mounting nuts from the injector sight shield (top engine cover). See Figure . Lift the sight shield from the front and pull forward to disengage the rear tab from the bracket. Disconnect the bank 2 Ignition Control Module (ICM) electrical connector.
  2. Using the removal sequence, remove the ignition cassette retaining bolts. See Figure . Carefully remove the ignition cassette. See Figure . Remove ignition coil(s) from ignition cassette as necessary.
scientia non olet · About LEMON Manuals