EGR Pipe: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Loosely install the EGR pipe nut to the crossover exhaust pipe. Lower the vehicle. Install the bolt at the water pump housing. Tighten the water pump housing bolt to specification. See TORQUE SPECIFICATIONS .
Raise and support the vehicle. Tighten the EGR pipe nut to specification. Lower the vehicle.

Fig 1: Removing/Installing EGR Pipe

Courtesy of GENERAL MOTORS CORP.