LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 368 (Engine Controls - Removal & Installation) >> Air Induction Systems >> Throttle Body >> Installation

Throttle Body: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the NEW throttle body gasket on to the throttle body. Install the throttle body. Tighten the throttle body bolts to specification. See TORQUE SPECIFICATIONS  . Install accelerator control bracket bolts to the throttle body.
  2. Install the IAC valve electrical connector. Install the TP sensor electrical connector. Install the accelerator control cable at the throttle body lever. Install the cruise control cable at the throttle body lever. Install the accelerator control cable to the accelerator controls cable bracket.
  3. Install the cruise control cable to the accelerator controls cable bracket. Install the transaxle shift cable clip to the accelerator controls cable bracket. Install the fuel feed and return lines from the retainer on to the accelerator controls cable bracket. Install the MAF/IAT sensor electrical connector.
  4. Install and tighten the air cleaner intake duct clamp. Install the PCV valve fresh air tube. Align and press the injector sight shield onto the mounting studs. See Fig 3 . Install the mounting nuts onto the mounting studs and tighten nuts. Install the negative battery cable. Install the rear seat cushion.
Fig 1: Removing/Installing PCV Air Tube
G00217051Courtesy of GENERAL MOTORS CORP.
Fig 2: Locating EGR Valve, EVAP Canister Purge Valve & MAP Sensor
G00053850Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing/Installing Fuel Injector Sight Shield
G00217048Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals