LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 366 (Automatic Transmission Removal & Installation - (AWD)) >> Removal & Installation >> Transaxle Mount (Left) >> Installation

Transaxle Mount (Left): Installation

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the 3 left transaxle bracket and bolts. Tighten to specification. See TORQUE SPECIFICATIONS .
  2. Install the left transaxle mount and the 4 bolts. Tighten to specification. See TORQUE SPECIFICATIONS .
  3. Install the transaxle mount through bolt. Tighten to specification. See TORQUE SPECIFICATIONS .
  4. Remove the engine support fixture.
  5. Install the air cleaner box.
  6. Install the 3 air cleaner box bolts.
  7. Install the air filter.
  8. Install the air cleaner hose and cap assembly.
  9. Install the IAT sensor.
  10. Connect the IAT connector.
  11. Install the battery tray and battery.
  12. Install the hold down bracket.
  13. Install the hold down bracket bolt and nut. Tighten to specification. See TORQUE SPECIFICATIONS .
  14. Install the positive and negative battery cables.
scientia non olet · About LEMON Manuals