LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Engine Controls - Removal & Installation) >> Sensors >> Crankshaft Position Sensor >> Installation

Crankshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure CKP sensor mounting surface is clean and free of burrs. Using a NEW CKP sensor "O" ring lubricated with clean engine oil, install CKP sensor into timing cover.
  2. Ensure CKP sensor is fully seated into timing cover before tightening mounting bolt. A poorly seated CKP sensor may perform erratically and may set false DTCs. Install CKP sensor mounting bolt and tighten to specification. See TORQUE SPECIFICATIONS  .
  3. Reconnect CKP sensor harness connector. Install steering linkage shield and tighten mounting bolts to specification (if equipped). Lower vehicle. Perform Crankshaft Position Sensor Variation Learn Procedure. See CRANKSHAFT POSITION SENSOR  under PROGRAMMING.
scientia non olet · About LEMON Manuals